|
Title: Need proper cable to start data logging. Post by: cederrowe on April 15, 2014, 09:53:22 AM Any good links to proper cable.
Ordered two cables and both companies never sent off ebay (got refund), and alphabid "recommended" changed there chip from the recomended 232r if i remember correctly but does work for vcds. Any links to working cable to order? So I have been stuck data logging with vcds which is to slow sample rate. Thanks for any info. Title: Re: Need proper cable to start data logging. Post by: SB_GLI on April 15, 2014, 12:33:10 PM I'd think you could use whatever cable you are using with Vag-com right now. Perhaps you need to install virtual com port drivers to emulate a com port. Just make sure you specify the proper com port to use with ME7Logger.
Title: Re: Need proper cable to start data logging. Post by: cederrowe on April 16, 2014, 08:45:31 AM I downloaded the drivers ftdi?
Then installed them went to drivers hardware and selected the correct port. Nefmoto wont connect, and I get a error with ME7 logger Which com option should I be selecting? Also I have to drop my stock ecu file in the ME7 logger? What if its allready on Nefmoto tune? Title: Re: Need proper cable to start data logging. Post by: ddillenger on April 16, 2014, 09:36:56 AM You need to uncheck "boot in intelligent mode" in the VCDS options.
|