|
Title: Cant get any of my cables to work with NefMoto software. Please help. Post by: desha on July 09, 2014, 12:32:43 PM I have both a real Rosstech cable and e-bay cable. I use the rosstech cabel often with VCDS. I never have issues. Unfortunatly, I have been unable to get either cable to work with NefMoto software. I have disabled the boot in intellegent mode in VCDS. I have tried to uninstall and install FTDI drivers multiple times. When I enter NefMoto or refresh devices, a RossTech hex cable appears in the device field. however, when I try to connect I get "Could not open FTDI device". if I refresh the device and try again I get "Failed to read test echo from FTDI device". These two messages alternate.
What have I missed? Is there a hidden driver I have failed to uninstall or something. Any help would be greatly appreciated. Thanks in advance. Title: Re: Cant get any of my cables to work with NefMoto software. Please help. Post by: desha on July 18, 2014, 07:06:50 AM Please someone... anyone...
190 something views and no responses. :'( I need some guidance. any advice will be appreciated. Can I bribe someone to help!????? I have lots of knowledge and skills to trade too. Title: Re: Cant get any of my cables to work with NefMoto software. Please help. Post by: vdubnation on July 18, 2014, 07:09:46 AM i can help pm me and i ll remote in and take a peak
Title: Re: Cant get any of my cables to work with NefMoto software. Please help. Post by: corneliusmixon on July 27, 2014, 10:05:53 AM I'm having the same issue.
Title: Re: Cant get any of my cables to work with NefMoto software. Please help. Post by: vdubnation on July 28, 2014, 06:55:27 AM pm me
Title: Re: Cant get any of my cables to work with NefMoto software. Please help. Post by: nyet on July 28, 2014, 09:45:28 AM Guys, please don't keep the solution to PM. Post results so we don't see this damn question over and over and over and over and over again.
Title: Re: Cant get any of my cables to work with NefMoto software. Please help. Post by: vdubnation on July 28, 2014, 11:42:13 AM 99% of the time its user fault i just check to see if they installed the driver properly have netframe work which most miss dont know how .
I m offering to remote in and just check i usually post the outcome if i helped. Going to make a video how to install everything. Title: Re: Cant get any of my cables to work with NefMoto software. Please help. Post by: nyet on July 28, 2014, 11:43:04 AM Thanks!!
Title: Re: Cant get any of my cables to work with NefMoto software. Please help. Post by: Ballistix234 on August 24, 2014, 06:45:51 PM Not saying this will help for you, but it did it for me. I had bought 2 cables from ebay with no success at all with the second cable, first cable i kinda got to work, but not seamlessly. They both had issues with K lines, one even said short to ground, I was kinda like... omf what is the hell is going on with my car...!?
So... It bought a rosstech hex can cable.. from rosstech. Expensive Yes but... works great! with Vcds! Not so good with Nefmoto out of the box. What I had to do, to get it to work with Nefmoto, (on my car) was put the cable in dumb mode. Go into vcds and uncheck Force dumb mode and test and save. then try nefmoto. Good luck! |