Pages: [1]
Author Topic: Knock sensor g61 signal too low  (Read 5659 times)
jogtx16v
Full Member
***

Karma: +6/-1
Offline Offline

Posts: 139



« on: August 23, 2016, 02:52:51 PM »

I got this fault code sometime. I have the car over 5years now and never find why this code occur.

16711 -  Knock Sensor 1 (G61): Signal too Low
        P0327 - 35-00 -   -

The car is vw jetta 1.8t 2002


thing I have do to find the issue.
-some used knock sensor torqued at 20nm
-New knock sensor for dealer torqued at 20nm
-Wiring from knock sensor to ecu plug tested very good in ohms
-tested couple other ecu's

I need help, can datalogging of knock voltage can help to see what happen ?
Logged
jogtx16v
Full Member
***

Karma: +6/-1
Offline Offline

Posts: 139



« Reply #1 on: August 24, 2016, 09:34:01 AM »

I search for all possible cause. desesperate  Undecided
Logged
10101011
Full Member
***

Karma: +10/-13
Offline Offline

Posts: 161



WWW
« Reply #2 on: August 24, 2016, 10:39:37 AM »

I have seen in the past when the other knock sensor (G66) is reading high but the computer gets confused and post a fault code for " SIGNAL TOO LOW " for the other sensor (G61) .
Logged

Poor quality lingers long after the price is forgotten ....
overspeed
Sr. Member
****

Karma: +21/-5
Online Online

Posts: 387



« Reply #3 on: August 24, 2016, 12:04:26 PM »

I have seen in the past when the other knock sensor (G66) is reading high but the computer gets confused and post a fault code for " SIGNAL TOO LOW " for the other sensor (G61) .

Me too... but not in all Sw versions it occurs... it shall have some kind of filter, but I´m too lazy to look for in german FR   Cheesy
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 18 queries. (Pretty URLs adds 0s, 0q)