Pages: [1]
Author Topic: Electricuted by Car while tuning.  (Read 7059 times)
eakinsj
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 17


« on: October 01, 2016, 07:32:59 AM »

So last night I was changing the tie rod on my 2.7 and I though oh I can flash my tune while in changing the tie rod.

So I go grab my computer which has a terrible battery life. I plug the charger in and hook the compter up and I get the tune flashing.

I reach in to start adjusting my tie rod and felt a shock on my left hand. I figured I just pinched a nerve or got stabbed by a piece of steel or something. So I reached it again. This time on my other arm I touched the fender and got shocked.

So I went and grabbed my continuity tester and found that somehow the whole car was charged with a.c. power. And I mean the whole car. Any where with bare metal would electrocute you.

Now I'm assuming it is an issue with my laptop but I am not sure. The tune flashed fine and car runs great.
 
Just posted this to see what people think.
And to warn them you're car could be trying to kill you.
Logged
vwaudiguy
Hero Member
*****

Karma: +53/-37
Offline Offline

Posts: 2024



« Reply #1 on: October 01, 2016, 07:36:04 AM »

Was this car on a lift?
Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
eakinsj
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 17


« Reply #2 on: October 01, 2016, 08:25:32 AM »

No it was on all 4.
Logged
eakinsj
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 17


« Reply #3 on: October 01, 2016, 08:26:42 AM »

What blows my mind is a.c. power should not go past the charging block of the laptop. And I tried 2 different chargers and different extention cords.
Logged
adam-
Hero Member
*****

Karma: +124/-33
Offline Offline

Posts: 2179


« Reply #4 on: October 01, 2016, 11:43:43 AM »

Tried two different chargers and they both make the car hot?
Logged
eakinsj
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 17


« Reply #5 on: October 01, 2016, 03:11:43 PM »

Yes. Blows my mind I just don't understand, how it is even possible. You would think 110 a.c. would fry the motherboard of the pc.
Logged
gman86
Hero Member
*****

Karma: +45/-128
Offline Offline

Posts: 705


« Reply #6 on: October 01, 2016, 05:20:41 PM »

Switched mode PSU ties -ve against the AC side. Sounds like a poor PSU. There is a filtering cap between the two sides. It's normal to feel a slight "nibble" if on any low impedance body part (sweaty hand/finger) due to capacitive coupling, but not a shock. Sounds like yours is leaking or isn't grounded properly.
Logged
DT
Full Member
***

Karma: +20/-1
Offline Offline

Posts: 184


« Reply #7 on: October 01, 2016, 10:40:28 PM »

Most probably not a shock. Listen to gman86
Logged

adam-
Hero Member
*****

Karma: +124/-33
Offline Offline

Posts: 2179


« Reply #8 on: October 02, 2016, 11:28:09 AM »

But for both to have failed?
Logged
gman86
Hero Member
*****

Karma: +45/-128
Offline Offline

Posts: 705


« Reply #9 on: October 03, 2016, 02:19:52 AM »

But for both to have failed?

I suspect it's said "nibble" I was talking about. If true AC was in the vehicle electrical system, I suspect it would hurt some stuff.

I've seen upto 90v float between the -ve output of a PSU and the supply earth. The problem is, there's absolutely zero current available so any sort of load drops that voltage to pretty much 0.
Logged
overspeed
Sr. Member
****

Karma: +21/-5
Offline Offline

Posts: 387



« Reply #10 on: October 05, 2016, 06:09:52 AM »

Happens the same yesterday with an A3 2002 with M3.8.3 in dynamometer...

Logged
vwaudiguy
Hero Member
*****

Karma: +53/-37
Offline Offline

Posts: 2024



« Reply #11 on: October 05, 2016, 12:04:31 PM »

Shockingly fast!
Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.024 seconds with 16 queries. (Pretty URLs adds 0.001s, 0q)