Hello! This is probably the most asked question on this forum, i have searched but i can't seem to understand what to change in the binary file.

Removal
If you want to disable your EGT sensors:[74] (Note that my old M-box xdf is wrong[75] for CDATR/ATS. Please use these offsets.)

CDATR (0x18196) - Configuration byte diagnosis exhaust gas temperature regulation
CDATS (0x18197) - Configuration byte diagnosis exhaust gas temperature sensor
CATR (0x192CA) - Configuration byte exhaust gas temperature regulation (disables ATR)[76][77][78]
Alternately, setting both of these to their maximum (1229) may help: [79]

TABGSS (0x1C514) and TABGSS2 (0x1C516) - Desired exhaust gas temperature for EGT regulation
You shouldn't have to touch these, but are included here for completeness:

CLAATR - Error class exhaust gas temperature regulation
CLAATR2 - Error class exhaust gas temperature regulation bank 2
CLAATS - Error class exhaust gas temperature sensor
CLAATS2 - Error class exhaust gas temperature sensor bank 2

I get the TABGSS part, just raising the values to the maximum, is this the way to go? Or do you change CDATR CDATS CATR and what should i change it to?

I have a C euro box. I have attached my binary file. It is tuned to stage 1 at some point in its life. At some company but i'm not sure what they have changed.

Cheers from sweden!

using WINOLS searching for "CDATR, CDATS, CATR" All that get highlighted is set to "00"

The adress seems to be between 70B60 and 70BC0