https://github.com/bri3d/ghidra_tc1791_registers

Place these files in Ghidra/Processors/tricore/data/languages.

Memory maps are still not yet complete, you probably want to set up your own based on your specific disassembly project anyway. But, I generated the register list off of an official definition so it should be fairly accurate. Especially useful if you are looking at early-stage boot code like Internal ROM or SBOOT.

This doesn't touch the instruction model, just the register specs.

Figured it out.
Need to define the function first, as it doesn't define any automatically. As soon as the function is defined the decompiler view turns white.
Also the binary needs to be 10mb and have the 4mb gap in the middle included. Or you need to load PFLASH0 and PFLASH1 separately.

Definitely a nice tool as a complement to IDA, but for general disassembly IDA is still my go-to tool.

Could you give me some precision about this?
I'm in the same position as you were, but from on a TC1793. I do not understand why the file needs to be 10mb large with a gap or how did you figure it out.
Specs/datasheet list the following memory locations:


I have dumped a 4194304 bytes long file (exactly 4MB) for the PFLASH. I'm not sure if there is a better user manual, but I've found the following: https://www.infineon.com/dgdl/Infineon-TC1793-DS-v01_02-en.pdf?fileId=db3a304333227b5e013368d702f5176b for my case. Are you saying this 4MB file needs to be split at a specific location, such as I can insert it into Ghidra in two times with the following placement:

0x0 - PFLASH0
.
.
0x???? - 4MB GAP (@PFLASH0 + PFLASH0_SIZE)
.
.
0x???? - PFLASH1 (@PFLASH0 + PFLASH0_SIZE + 4MB)
.
.
.
0xA00000 - END (@PFLASH0 + PFLASH0_SIZE + 4MB + PFLASH1_SIZE)


If yes, what is the split location, or put the size of PFLASH 0 and PFLASH 1 differently? Is the above layout correct?

Any help to set up this project so I can start trying to make sense out of it would be greatly appreciated.

I've tried this before asking here, unfortunately the only thing I found that is somewhat relevant is the Datasheet that I've linked in the post above.
I've also managed to get some header files, which would be useful for development, but I'm not there yet. Nothing looking like a proper user manual or developer guide, unfortunately.

Is it common for those to not be accessible at all? How do you guys get a hand on them?

This is helpful, thank you. I was trying to find documentation specifically for the TC1793 to avoid making false assumptions later on due to any differences with 1791 or 1798.
Since you're suggesting this one, I'm guessing the differences aren't significant enough to matter.

A TC1798 is the same as a TC1791 and TC1793, all are AudoMAX.
The differences are mainly clockspeed, amount of memory and adc module count.