Pages: [1]
Author Topic: fully bricked me7.5 ecu  (Read 1266 times)
bazs022
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 2


« on: April 08, 2024, 09:49:06 AM »

hello
i accidentally fully bricked my me7.5
edited the original program and forget the checksum corrector
now the car won't start and I can't read and write the ecu
I tried boot mode but it also didn't work
my apps ran out of 10 use
i have kess v2 (china) and galetto 1260
any ideas to save. this ecu?
Logged
dal
Full Member
***

Karma: +6/-7
Offline Offline

Posts: 210


« Reply #1 on: April 08, 2024, 10:55:37 AM »

galetto 1260 with bootmode. very easy.
Logged
BlackT
Hero Member
*****

Karma: +79/-40
Offline Offline

Posts: 1425



« Reply #2 on: April 08, 2024, 11:07:00 AM »

Unplug possitive battery for 2 minutes. You can start car after that, flash tune also
Logged
bazs022
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 2


« Reply #3 on: April 08, 2024, 02:34:04 PM »

I tried boot mode in my desk, in the car, unplug the battery, boot pin 1 sec 5sec 10sec
And still no response
Galetto: boot mode inactive
Kess v2: unknown ecu type and wake up error
Logged
BlackT
Hero Member
*****

Karma: +79/-40
Offline Offline

Posts: 1425



« Reply #4 on: April 09, 2024, 12:27:21 AM »

Don't put power to pin 121 when you try boot mode
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.027 seconds with 16 queries. (Pretty URLs adds 0.001s, 0q)