Pages: [1]
Author Topic: Fans running after Wideband conversion from APP to BAM  (Read 872 times)
RavenT
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 17


« on: February 24, 2025, 03:58:17 PM »

Hey guys,

I have a Problem with a TT MK1 APP after converting it to wideband ECU (i did a Lot of wideband Swaps so far).

The Fans are running on second Stage as soon as i Turn ignition on and keep running also when the Engine is running.

I Had this issue once 5 years ago but i can't get the solution Back in my mind...

If i Plug Back the APP narrowband Ecu No issues with the Fans so there must be anything with the Wideband Ecu / Signal Output to cause the Fans running...

I Hope someone Here had this issue also and can Help my mind to recognize what the Problem was...
Logged
dal
Full Member
***

Karma: +7/-8
Offline Offline

Posts: 219


« Reply #1 on: February 24, 2025, 05:58:07 PM »

As I can remember, its the pin 61.
Logged
RavenT
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 17


« Reply #2 on: February 24, 2025, 06:38:00 PM »

You know what is the Problem with Pin 61? I am looking at the wire diagrams of both Cars and can't figure it out...
Logged
aef
Hero Member
*****

Karma: +72/-48
Offline Offline

Posts: 1635


« Reply #3 on: February 24, 2025, 11:38:11 PM »

Remove the cable/pin in Pin61 and move it to the side.
Logged
RavenT
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 17


« Reply #4 on: February 25, 2025, 03:18:57 PM »

Thank you this was the Problem.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.02 seconds with 15 queries. (Pretty URLs adds 0s, 0q)