Hello,
I'm working on device which reads values using kwp2000(89) using k-line and presents on FIS display generally with success
but have problem with mapping initial unit adres (used in slow-init)  to target address set in kw200 frames e.g.:
for ecu slowinit addres  =1 kw200 target also =1
for tacho slowinit addrs =17 target should be 61, for immo yet another one
(those addresses I found by sniffing..)

Can anyone give hint, what about other units, how target addresses are calculated/maped from slowinit addreses ?

thx and regards

     

After KB1 and KB2, units send one byte for which I didn't find definition,
it is for tacho          68 -> kw2k tgt 61
for immo (@tacho) da -> kw2k tgt c0
which look sligthlty similar, maybe here is a way ?
eventually can I find definition of kw2000 targets ?

thx again