I'm getting this error when I try to validate my memory layout. Couldn't find any mention of it when searching, so I'm starting a thread now.
Disabling Windows sleep mode.
Validating memory layout.
Reading ECU identification option: calibrationEquipmentSoftwareNumber
Read ECU identification option with unknown scaling record.
Successfully read ECU identification information
ECU reports programming session preconditions have been met.
Negotiating communication timings.
Successfully changed to new communication timings.
Requesting security access.
Security access granted.
Starting diagnostic session.
Successfully started diagnostic session.
Requesting security access.
Security access granted.
Validating flash memory starts at 0x00800000 and ends at 0x00900000.
Validation failed, ECU reports RequestUpload was rejected. RequestUpload may have been disabled by aftermarket engine software.
100% complete.
Validating memory layout failed.
Restoring Windows sleep mode.
I am 100% sure my ECU is stock and does not have software on it.
The car is a 2001.5 B5 S4 with an M-box. Memory layout is ME7 29F800BB. Is it possible it's one of the other layouts? Looking in the wiki, there are no other options listed for the 2.7T.
