Pages: [1]
Author Topic: MPPS - ECU NO REPLEY  (Read 7480 times)
b0ki
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 14


« on: August 17, 2011, 06:06:48 AM »

I have  MPPS clone version it always worked fine  last days it would brick every ecu i work with it. It starts flashing and then i get MSG NO REPLAY  FROM ECU.  After that the car will not crank and i have to bench flash it with gallot.  I notice when do slow mode flashing with mpps it works fine. Any idea ?
Logged
Jason
Hero Member
*****

Karma: +38/-0
Offline Offline

Posts: 500


Breaks everything!


« Reply #1 on: August 17, 2011, 11:26:47 AM »

Have you recently changed software versions?
Logged
b0ki
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 14


« Reply #2 on: August 31, 2011, 05:24:00 AM »

Yes i did. any advice ?
Logged
infinkc
Full Member
***

Karma: +6/-1
Offline Offline

Posts: 94


« Reply #3 on: September 01, 2011, 11:21:16 AM »

Yes i did. any advice ?

what version to what version? some clones you cannot upgrade the software on or it will burn out the chip in the cable.  Its a security that they put into having the original vs clone.
Logged

vwaudiguy
Hero Member
*****

Karma: +53/-37
Offline Offline

Posts: 2024



« Reply #4 on: September 01, 2011, 04:31:35 PM »

What was the reason for changing software versions?
Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
chienliu1972
Full Member
***

Karma: +5/-0
Offline Offline

Posts: 50


« Reply #5 on: October 18, 2011, 09:08:25 AM »

If you have updated to MPPS V5 firmware of hardware, you need a patch file of MPPS V5. Cause your MPPS V3 clone hardware would not be used in MPPS V5 again.
« Last Edit: October 19, 2011, 12:25:54 AM by chienliu1972 » Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.018 seconds with 17 queries. (Pretty URLs adds 0.001s, 0q)