Pages: [1]
Author Topic: Is it possible to write 24c02.bin on board via clip...  (Read 5177 times)
Mo Arif
Jr. Member
**

Karma: +0/-1
Offline Offline

Posts: 29


« on: September 08, 2014, 01:13:04 PM »

...on a Bosch Me 3.8.3 ECU, i've researched a bit and getting mixed answers, some say no you can't it will fry, has to be de-soldered yet others say you can if you give a particular pin a 12v or Ground? please can someone confirm this.

 Smiley
Logged
Mo Arif
Jr. Member
**

Karma: +0/-1
Offline Offline

Posts: 29


« Reply #1 on: September 15, 2014, 07:08:40 AM »

Anyone? I'm able to de-solder the chip and replace it; but i heard it's possible to so without removing the chip.
Logged
ddillenger
Moderator
Hero Member
*****

Karma: +641/-21
Offline Offline

Posts: 5640


« Reply #2 on: September 15, 2014, 07:12:39 AM »

I tried powering the ecu, then writing in circuit. It failed both times I attempted it.

Now I just remove the eeprom.
Logged

Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your experience!

Email/Google chat:
DDillenger84(at)gmail(dot)com

Email>PM
f1torrents
Sr. Member
****

Karma: +17/-1
Offline Offline

Posts: 303


« Reply #3 on: September 15, 2014, 07:36:23 AM »

I have also had no sucess doing it on the board.
Just remove.

I even tried shorting the crystal oscillator, but I did nothing.
Logged
eliotroyano
Hero Member
*****

Karma: +48/-8
Offline Offline

Posts: 825


« Reply #4 on: October 07, 2014, 05:33:13 AM »

According to some VAG documents is should be possible to read it through OBD port.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.016 seconds with 17 queries. (Pretty URLs adds 0s, 0q)