Pages: [1]
Author Topic: exhausting tuning  (Read 3660 times)
ktm733
Hero Member
*****

Karma: +18/-8
Offline Offline

Posts: 660



« on: December 17, 2014, 09:46:17 AM »

Can some point me in the right direction of what to tune for exhaust or faqs about exhaust tuning? There's a back pressure change which increases engine scavaging. Which in turns bring more fresh air in, which in turn you need more fuel brought in also to get requested air fuel ratio. Ive searched and there is nothing about exhaust tuning. Wouldn't less more fresh air mean more efficiency?
Logged
kingkhalilz
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 123


« Reply #1 on: January 09, 2015, 08:48:36 PM »

The amount of mass moved through the motor doesnt change the efficiency, increasing the rpm sure sucks more mass but not more efficient. Only increasing the temperature of the motor does or decreasing the intake temp. Thermo stuff. Its such a small modification i doubt it opens much up however thats what your maf sensor is for. Your car will automatically adjust fuel if more air flows in up until a point. Exhaust alone is not close to this point i think.

I am by no means an expert with this stuff. Grain of salt
Logged
nyet
Administrator
Hero Member
*****

Karma: +607/-168
Offline Offline

Posts: 12268


WWW
« Reply #2 on: January 10, 2015, 04:49:08 AM »

There is nothing to change except perhaps LDRPID, which should, in theory, require less DC for a given manifold pressure.
Logged

ME7.1 tuning guide
ECUx Plot
ME7Sum checksum
Trim heatmap tool

Please do not ask me for tunes. I'm here to help people make their own.

Do not PM me technical questions! Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your ex
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.017 seconds with 17 queries. (Pretty URLs adds 0s, 0q)