Hot swapping Flash chips after booting.

Pages: [1]

« previous next »

Author

Topic: Hot swapping Flash chips after booting. (Read 3655 times)

carlossus

Sr. Member

Karma: +38/-0
Offline

Offline

Posts: 394

Leon Curpa Stg1+

	Hot swapping Flash chips after booting. « on: November 04, 2011, 05:29:56 AM »

I’m making a simple flash chip selector circuit so I can toggle tunes using the number of pulses on the ignition switch.
I need to be able to boot from A then switch to B to be able to flash a blank or corrupted device and vice versa. Are there any implications in doing this say.. 10 seconds after boot time?

e.g.
Enable Flash A (with good image)… . . . . . . . . . . . . . .Boot… . . . . . . . . . . . . . .Wait 10s… . . . . . . . . . . . . . .Enable Flash B… . . . . . . . . . . . . . .Connect Nefmoto and re-flash over blank image.
Or can I reduce this time somewhat?
Thanks.


	Logged

kls

Full Member

Karma: +12/-0
Offline

Offline

Posts: 97

	Re: Hot swapping Flash chips after booting. « Reply #1 on: November 06, 2011, 01:04:44 PM »

I used this technique via a toggle switch and the CE# line - worked fine all but one time. To really know if the flash gets accessed at other times you'd need to scope it.


	Logged

Pages: [1]

« previous next »

Jump to:

Navigation

Personal Tools

November 24, 2024, 11:53:03 PM

Welcome, Guest. Please login or register.
Did you miss your activation email?

Navigation

Personal Tools

Search