esik
Newbie
Karma: +0/-0
 Offline
Posts: 3
|
 |
« on: September 09, 2018, 05:49:37 PM »
|
|
|
Hello
Car: ibiza cupra 6k2 1.8t AQX engine.
I want flash ecu by mpps via obd and he show error, he did not even start erase flash. Now i cant start the car. Only if i disconnect battery for few minutes, engine start and woring well, if the ignition is on second time epc is not present on dash and car is crancing and not start and i cant connect to ECU, until i disconnect battery.
Later it turned out ECU is chipped by MTM, and have encryption board with Intel PA28F400 flash.
I gave ECU for local tuner and he desolder out the encryption board and solder only Intel flash with stock bin and everything is ok until i want another flash kess via obd and now i have the same situation, engine start ony after disconnect battery.
Now in cant flash even in boot mode.
Flasher says THIS-IS-THE-RAM-PROGRAM.
ECU has none DTC.
I do a lot of diesel EDC, and this is my first ME...
What should i do to make it ok?
Sorry for my EN.
Regards
|
|
|
|
« Last Edit: September 09, 2018, 05:53:16 PM by esik »
|
Logged
|
|
