Hello to all.

Trying to work out simple stuff like DTC removal/forced readiness for my 1.8T (8N0906018AE, ME7.5, 1.8T 2250HP). I have fitted the audi TT APX engine to Vw bora 4 motion and i will use the car off road only( on the track).
I have removed EVAP Purge Valve (N80);Secondary Air Pump Relay (J299);Secondary Air Injection Solenoid Valve (N112).
I have the original bin if that helps, and also wit the help of the friend i have managed to delete the faults. But according to forum rules i can not post modified files.
My main problem is that after the fault codes removal from the sw i have not completed the Readiness and the lambda control is in open loop: 
NUmber of DTCs store:0--Mil status OFF
Misfire monitoring:not installed
Fuel System: Not installed
Comprehensive components: Passed
catalyst monitoring: Failed or incomplete
Heated catalyst monitoring: not installed
Evaporative system monitoring: Not installed
Secondary air system monitoring: Failed or incomplete
A/C system refrigerant monitoring: not installed
oxygen sensor monitoring: Passed
Oxygen sensor heater monitoring: Passed
Exhaust gas re-circulation: Not installed

My problem is that lambda control is not working. I have a fault under obd: fuel system status: open loop due to system faults detected.
Although my lambda is working. I can see changes in lambda sensor voltage if i press accelerator. I am a afraid i could damage the engine if the lambda control is not working ? Or not ?

Can anyone please help me ? Or point out what i have done wrong in the sw ?



 




 

What maps did you change? Be specific.