Hello all.
I removed SAI pump from circuit (hose and wire) and i removed the N112 for it.
I understand exist a relay j299 for SAI? I must remove it or leave it there?
I want to the ECU skip fuel calculation for SAI and make a new calculation without it.
Please tell me if i change ESKONF by setting the appropriate bitpairs SLV (N112) and SLP (J299) to 11 ut is enought or it is only for not see error/ DTC in VCDS?
I must make changes in other parts like WIKI reference
"The first method sets the monitor to unsupported (falsely shown as PASSED in VCDS):

    CDSLS to 0
    CWKONABG bit 2 to 0 (e.g. change from 5 to 1).

However, if your SAI pump is dead or failing, it will cause cold start issues.[71] In addition, it will only show SAI unsupported, and NOT truly passed. To fix this, unplug the pump from the relay and modify

    MSLUB (0x1A698)
    MSLBAS (0x183CC)"

What is the best methode?
MANY MANY THANKS.

WHERE YOU SAW A JOKE???
I don't understand and i read WIKI.
Can you explain more clear about ESKONF if you are a GENIUS???
ESKONF exclude them from "fuel" calculation?

akk modification for removed sai and evap are done
will see tommorow at a cold weather

Yesterday (please see the post before EVAP and SAI removed from code like WIKI said) the car works greate at -2 degree.
Today is 12 degree and the car starts ok but after 10 seconds when i want to drive , it was very much fuel and tried to stop.
After drive 5 km and water was at 90 degree the car not work ok , some lose power and acceleration is very hard.
The idle is not stable (730-780rpm) and the afr is not stable too it fluctuates between 12.8 and 16.5
I had a removed catalysator from 10000km and not have any error but today after modified the file for ecu with modification for evap and sai i received this error
16804 - Catalyst System; Bank 1
            P0420 - 35-00 - Efficiency Below Threshold

In vcds the readlines for evap and sai passed but o2 and catalyst NOT.

Readiness Status: 0110 0001
Exhaust Gas Recirculation: Passed
Oxygen Sensor Heating: Failed or Incomplete
Oxygen Sensor(s): Failed or Incomplete
Air Conditioning: Passed
Secondary Air Injection: Passed
Evaporative Emissions: Passed
Catalyst Heating: Passed
Catalytic Converter(s): Failed or Incomplete

In obd torque for evap and sai , wrote "NOT SUPPORTED".
Please give me your advice.
WHAT can be?
Can be the ecu is in its first 50 km after i wrote the new file?
Must remove the rear O2 and cat ( O2 is plugged on car but without cat)?
Maybe now the ecu is much sensible without SAI OR EVAP functions and feel bad rear O2 sensor?

MERRY CHRISTMAS and thanks for your time!

Post the file.

Hi,

How did you get on with this, I'm trying to do similar with a me 7.5 1.8t.  I have read and re-read the wiki, and starting to understand it, but doesn't jump out for answer for going cat delete but keep rear o2 sensor, I assume obviously there is a variable that looks for the difference in EGTs to find if the cat is working, but it doesn't jump out to me.

Thanks

Gav