Hello folks,

i just looking for a tool, which can read an write the DSG of 2011 GTI. I read on the internet, that the Kess c-l-o-n-e should be able to do this. You need a additional 20-Pin-Connector to read direct on the TCU. After the direct read it should be able, also to write through the OBD-Port. Is it true?

Did someone some reads an write on a 2011 DSG from a Golf 6 GTI? How to handle kess and dsg?

Alternatively better but Mini-DSG-Reader?

What are your experiences and what will you prefer?

Kess V2 CL can read/write my 07 DQ250 via the OBD port.

I imagine going directly through the TCU would work on yours.

Thank you for your reply’s!

I’ve tried yesterday to read with 5.017 and 2.53 through the OBD-Port, but wasn’t possible.
So that I grab some wire's, connector's and a Switch. I take some of the cable work from the Internet and build one of this DSG DQ250 „direct cable's“. And see there, is works fine!

So know I have the directly read from the TCU and can workout my stuff on the DSG and also do my internal developments. Because I have tried for now 4 DSG tunes and all of them was rubbishy!!! Every tune had his good points but the last one was not really able to figured out, where are all of the torque limiters, so that my stage 2 Car was only put 395Nm. The ECU brings something around 440Nm.

I also drive mostly on the race track (Salzburgring and Nordschleife) with the car and I don’t need only super fast gear changes , I need a package in general, with is really custome tune not only increased shift tables and times.

That is the reason, why I actually ask this question above! So I will tray to write the File back through the OBD-Port and will see, what if it works and what happens. If it doesn’t work, I will write it back directly on the TCU with additional DQ250 cable.
Last but not least, there is also a Original VCP in house. ODIS 5-1-6 is also avaiable.

I will post my results. But maybe there are other petrolheads, with have tried and can report some to this. I will also put the ID from the read. 
________________________________________
Here the ID from the read:
HW: 02E927770AL
SW: v0697h0402ea__getriebe_DSG_Oh7h
VIN:
SW Ver.:
Teile:
Motor:
HW Ver.:
SW Upg.: 02E300054L  2604
Anlage: GSG DSG AG6     511

Kess Clone only by TCU

Hi!

To me reading and writing DQ250 (02E....) worked fine servery times up to now. So checksum correction is also done properly done by the clone. OBD writing is not applicable.

It wont work with MQB DQ250 i think! Better do not try!

Somebody tried this with DQ500 already???

Dont do it!

X-Boost Performance