Hello all, this my first experience with the software and im not having much luck.
I tried reading the contents of my ECU yesterday with a blue ebay cable, however it would not work.
My ECU used to have a GIAC Map but this should of been removed by VW when I tried to swap ECU's with another car (which didnt work). The only way to get the cars running again was to flash them with a stock VW Map.
So as far as I am aware my ECU is now standard but I am unable to read from it. any ideas where I could be going wrong.
This is my status log.
Validated FTDI device is in dumb mode.
Disconnected
Connecting...
Starting slow init connection.
Connecting to address 0x01.
Slow init succeeded.
Switching to KWP2000 session.
Sending start communication request.
Connected
Disabling Windows sleep mode.
Reading ECU flash memory.
ECU reports programming session preconditions have been met.
Negotiating communication timings.
Successfully changed to new communication timings.
Requesting security access.
Security access granted.
Starting diagnostic session.
Successfully started diagnostic session.
Negotiating communication timings.
Successfully changed to new communication timings.
Requesting security access.
Security access granted.
Validating flash memory starts at 0x00800000 and ends at 0x00900000.
Validation failed, ECU reports RequestUpload service is not supported. RequestUpload may have been disabled by aftermarket engine software.
Memory layout validation failed.
Starting to read data block.
Calculating flash checksum to determine if reading is necessary for range: 0x00800000 to 0x00804000
Flash checksum does not match, reading flash data is necessary.
Requesting upload from ECU for address range 0x00800000 to 0x00803FFF.
Request upload from ECU failed, ECU reports service is not supported. Request upload may have been disabled by aftermarket engine software.
Reading ECU flash memory failed. Trying to force ECU to recognize read operation is complete.
Finished forcing ECU to recognize that failed read operation is complete.
Reading ECU flash memory failed.
100% complete.
Restoring Windows sleep mode.
