Pages: [1]
Author Topic: possible fried ecu - boot mode  (Read 4974 times)
airtite
Hero Member
*****

Karma: +13/-3
Offline Offline

Posts: 741


« on: June 14, 2012, 02:23:20 AM »

Hi

was going too do an eeprom write, opened the ecu and connected too my bench harness while shorting pin 24 the cable slipped and shorted too pin 23 now I cant get comms too the ecu at all, already PMed notorius and he says he doubts that it would fry the ecu any other comments or suggestions on how to recover would be greatly appreciated.

Thanks
Logged
airtite
Hero Member
*****

Karma: +13/-3
Offline Offline

Posts: 741


« Reply #1 on: June 17, 2012, 11:32:46 PM »

anyone?
Logged
vwaudiguy
Hero Member
*****

Karma: +53/-37
Offline Offline

Posts: 2024



« Reply #2 on: June 26, 2012, 10:55:37 PM »

I suppose you could try a capacitive discharge? Which is basically shorting + to ground to drain the components on the board completely, then power back up? Never slipped in boot mode, but I'm sure someone has?
Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
airtite
Hero Member
*****

Karma: +13/-3
Offline Offline

Posts: 741


« Reply #3 on: July 04, 2012, 01:12:19 AM »

thanks for the reply
Logged
Stompen
Full Member
***

Karma: +5/-0
Offline Offline

Posts: 95

2002 Audi A4 1.8T


« Reply #4 on: July 05, 2012, 04:09:59 PM »

I`ve slipped a few times, and for the next 30-40 minutes or so, I cant connect to the ecu.
If I leave it overnight it always works fine again the next day, probably for the same reason vwaudiguy mentions... it takes some time to drain the circuits..

Good luck Smiley
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.016 seconds with 17 queries. (Pretty URLs adds 0.001s, 0q)