Pages: [1]
Author Topic: communication error(s) during flashing, log and original bin attached.  (Read 3235 times)
ddillenger
Hero Member
*****

Karma: +641/-21
Offline Offline

Posts: 5640



I knew this car was going to be a bear as nearly every time I've tried reading the ecu it always either

A: Reports security access was not granted/rejected
B: Reports security access is not supported

I have been able to start reading a few times (on those occasions security access was granted!) but all reads were painfully slow, and always failed between 7 and 30 percent)

Now I know the cable works as it flashes my 2000 a6 without issue. I finally was able to get a full read from the ecu after 7 attempts (I adjusted port speed and latency, not necessary on my other car), and decided what the hell, might as well give flashing a go. Anyway, I had to reconnect several times (cycling the key, then hitting reconnect, then re-writing the failed sector) before I was finally successful., Attached is the log. Any idea what gives? Is this common on immobilizer equipped cars?

Car is a 2001 audi a6 2.7t mt6, flash 4b0907551aa, original ecu contents (to my knowledge) with an active, working immobilizer. After the flash (flashed over to an m-box) Everything appears to be ok, but I'd like to reduce the amount of drama next time. Attached are the original ecu read, as well as my log from nefmoto.

A few additional details:

Yes, I connected and flashed via OBD
Yes, I had galletto (and a spare IMMO defeated ecu) ready for boot mode in case of a failed flash\
Yes, I had the car connected to an external power supply charging @ 13.5 volts.

Thanks for any help you can give me. Sorry for the extremely long post, but I figured better to be informative.
Logged

Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your experience!

Email/Google chat:
DDillenger84(at)gmail(dot)com

Email>PM
ddillenger
Hero Member
*****

Karma: +641/-21
Offline Offline

Posts: 5640


« Reply #1 on: November 05, 2012, 10:42:18 PM »

Here is the original read off the ecu. Anyone that wants to use it, feel free.
Logged

Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your experience!

Email/Google chat:
DDillenger84(at)gmail(dot)com

Email>PM
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 18 queries. (Pretty URLs adds 0s, 0q)