Pages: 1 [2]
Author Topic: EEPROM Checksum's and a possible error.  (Read 19285 times)
AmIdYfReAk
Full Member
***

Karma: +9/-0
Offline Offline

Posts: 129


« Reply #15 on: February 01, 2011, 11:17:37 PM »

This is all to weird, plugged it in, Program was on the wrong chip, error'd, changed its mode to 95040, Read/dumped the chip, it was junk, Programmed it with the correct bin and it programed without anything weird.

Is erasing the chip or anything needed prior? or was this ( Somewhat dumb ) move a stroke of luck?
Logged
kls
Full Member
***

Karma: +12/-0
Offline Offline

Posts: 97


« Reply #16 on: February 02, 2011, 01:02:47 AM »

Generally if you aren't getting a good read you shouldn't try writing to it. Did you read it to verify your write was successful?
Logged
AmIdYfReAk
Full Member
***

Karma: +9/-0
Offline Offline

Posts: 129


« Reply #17 on: February 04, 2011, 10:58:24 PM »

Quite a few times now, and each time its been 100% correct.

I feel as though the error of having the programmer on 27C256 while trying to read the 95040 caused some corruption.

i can continue to check, But its checked out Four times now on two separate occasions.
Logged
Tony@NefMoto
Administrator
Hero Member
*****

Karma: +132/-4
Offline Offline

Posts: 1389


2001.5 Audi S4 Stage 3


« Reply #18 on: February 05, 2011, 02:31:35 PM »

I have seen cases of corrupting the data on eproms when trying to read them using the wrong chip type.
Logged

Remember you have to log in if you want to see the file attachments!
Info or questions, please add to the wiki: http://www.nefariousmotorsports.com/wiki
Follow NefMoto developments on Twitter: http://twitter.com/nefmoto
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.016 seconds with 17 queries. (Pretty URLs adds 0s, 0q)