Hey all,

So I been a lurker on the site for some time now and its time for me to post because I can't seem to find a solution. I picked up a ecu (8E0 909 518 AF) as a spare in my 03 A4 1.8T AWD AUTO/Test cars. So I can play with the ecu without IMMO so I can plug and play between cars. I used ME7_95040 to Read the Eprom for the 95040. I put it on my test bench and threw the ecu into boot mode. I used command

m37_95040 -b9600 --bootmode -p 2 -r95040.bin

and I get uC identification response =0x00. Unknown ID.

Do I need to install a new 95040?

Thanks in advance for the help.

Thanks ddillenger I used the command and I still get the same error. See the attachment.

When I use NefMoto Boot mode I get this:

Connecting...
Starting bootstrap loader upload.
Sent bootstrap init zero byte.
Sent bootstrap init zero byte.
Sent bootstrap init zero byte.
Bootstrap loader upload failed. Failed to receive device ID response for init zero byte.
Disconnected
Disconnected
Connecting...
Starting bootstrap loader upload.
Sent bootstrap init zero byte.
Received device ID response for init zero byte.
Successfully uploaded bootstrap loader.
Received bootstrap loader started status message.
Starting upload of bootmode runtime.
Uploaded bootmode runtime data.
Sent baud rate detection byte.
Bootmode runtime upload failed. Failed to receive baud rate detection response message.
Disconnected
Connecting...
Starting bootstrap loader upload.
Sent bootstrap init zero byte.
Sent bootstrap init zero byte.
Sent bootstrap init zero byte.
Bootstrap loader upload failed. Failed to receive device ID response for init zero byte.
Disconnected
Connecting...
Starting bootstrap loader upload.
Sent bootstrap init zero byte.
Sent bootstrap init zero byte.
Sent bootstrap init zero byte.
Bootstrap loader upload failed. Failed to receive device ID response for init zero byte.
Disconnected

Thank you littco.. I have some spare 29F800 and 95040 laying around. I will just go out and buy another ecu and clone the eeproms. Thanks again.