Hi!
Today i broke this ECU and leaving my friend without car (((

We tried to read flash by nefmoto with no luck - getting "communication error"
when we try to put his ECU (8L0906018N - 512Kb narrow, no vvt) to my car (06A906032DR 1024 Kb, vvt) with same result
after playing with speeds we can read the file, and try to write new file at the same speed, but getting error about wrong memory layout (i choose 29F400) and after that nefmoto says something about problems with erasing and custom chip on this board. i choose cancel and we swapped ECUs back. And after that car wont start and getting the DTC 16706 - Engine Speed Sensor (G28): No Signal

So i have two questions. Maybe stupid but very important for me

1. Is it possible to fix this ECU? and how? immo off and flash in bootmode?
2. If not what ecu # can we use to flash it with 8L0906018N file ?

thanks a lot!

ecu are tuned
unfortunately we not opened it
i will try to make it in few days

but as i understand - if ecu has a childboard then i have no chance to read it. but it reads

so there is soldered chip
but problem was in broken g28 pin lol ))
after fixin it car starting and works ok

very strange.. so why these boards called 'encryption' if everyone can read it.. i always thinking that they are installed to read-write protection (copypaste protection)