I'm able to connect to the ECU at highest baud rate. After connecting, I lower baud to 38,400. In the KWP2000 Flashing tab, I choose the 29F800BB memory layout to full read flash. This is as far as I've been able to go:

29/Sep/2014 11:46:13.106: USER: Starting to read data block.
29/Sep/2014 11:46:13.110: USER: Requesting upload from ECU for address range 0x00800000 to 0x00803FFF.
29/Sep/2014 11:46:13.113: LOG: Sent message with service ID RequestUpload
29/Sep/2014 11:46:13.139: LOG: Received message with service ID: NegativeResponse
29/Sep/2014 11:46:13.141: LOG: Received negative response for service ID: RequestUpload, with response code: NoProgram
29/Sep/2014 11:46:13.146: USER: Request upload from ECU failed, ECU reports service is not supported. Request upload may have been disabled by aftermarket engine software.
--------------------------------------------------------------------------------------------------------------------------
29/Sep/2014 11:46:13.148: USER: Reading ECU flash memory failed. Trying to force ECU to recognize read operation is complete.
29/Sep/2014 11:46:13.151: LOG: Validating flashed data checksum for address range 0x00900000 to 0x00900001.
29/Sep/2014 11:46:13.156: LOG: Sent message with service ID StartRoutineByLocalIdentifier
29/Sep/2014 11:46:13.178: LOG: Received message with service ID: StartRoutineByLocalIdentifierPositiveResponse
29/Sep/2014 11:46:13.183: LOG: Sent message with service ID RequestRoutineResultsByLocalIdentifier
29/Sep/2014 11:46:13.202: LOG: Received message with service ID: NegativeResponse
29/Sep/2014 11:46:13.204: LOG: Received negative response for service ID: RequestRoutineResultsByLocalIdentifier, with response code: BlockTransferDataChecksumError
29/Sep/2014 11:46:13.207: LOG: Checksum is incorrect.
29/Sep/2014 11:46:13.209: USER: Finished forcing ECU to recognize that failed read operation is complete.
29/Sep/2014 11:46:13.230: USER: Reading ECU flash memory failed.
29/Sep/2014 11:46:15.687: LOG: Sent message with service ID TesterPresent
29/Sep/2014 11:46:15.704: LOG: Received message with service ID: TesterPresentPositiveReponse
29/Sep/2014 11:46:17.388: LOG: User Prompt - Title: Reading ECU Flash Memory Complete Message: Reading ECU flash memory failed. Result: OK
--------------------------------------------------------------------------------------------------------------------------

any suggestions?

  Yeah, right! I've seen your post about the collection of mouth-breathers at AR...doesn't exactly inspire confidence. Couldn't open that site anyway, dead link or something.

So what options do I have? New ecu, store-bought tune, etc...just to stop the bitchin' of the rear O2 sensors?? What a pisser!

You can also bootmode it