Hello, I have a KEE USB programmer. The 'About' tab of the software displays this:

App Software 6.16, Firmware 3.2.68, Model TL866CS

When I plug in a 29F800BB chip, the software does not display the ic config information.
I was hoping to see the protected/unprotected status of the chip. I tried programming
and erasing a spare, blank 29F800BB and that seemed to work fine, but again no config
information, or ability to set clear sector protection.

Is this a limitation of the programmer, maybe due to having to use an adapter to plug in
the chip?

I tried a different chip, AM29F002BB, and the software did show the configuration
information, and allows me to set/clear sector protection.