Hello.

Swapped in a '01 S6 4,2 (ANK) into my '97 B5, found a manual software on this forum and flashed into the ECU, works just fine (donor car was tiptronic).

But in the process of installing we decided to remove the SAI system and cats/rear o2 sensors.

So these systems are throwing fault codes and check engine light..

I think I've seen a version of the software here that had these things coded out....but I simply cant find it now..

Could someone help me ?

Hi Peiiider,

Did you find the file you were looking for yet?

I'm looking for the same thing, but to work on my ART engine.

For the .bin file you posted, what ECM did you put that into?  I see this is a 559E file, but from my understanding you can download this to a compatible ECM.  Did you download this to an ECM that is not the 559E ECM?  Maybe perhaps you used the 560AE ECM, which is ME7.1.1, from a 2001 AWN?
That's the ECM I'm trying to use, and I'm not sure I can simply download the 559E.bin file to that ECM.
Is this what you did?
If so, do you have the .xdf definition file you also used to download the file?

Thanks!