Hey Guys...
I need your help again...

I´ve finished my engine swap to my Polo 6N, all works fine but there is a little cosmetical thing that i would have to gone away.

I´ve two fault codes...

P1523 and P1649

They are because the Polo don´t have CAN Communication with ABS and Airbags (ABS and Airbags are still mounted but original from the Polo and they don´t have CAN).

I want to hide these codes, i´ve read that i´ve to edit CW_CAN_R and CW_CAN_C.

But i don´t know how to find the correct parameters
I´ve a well defined XDF from fukenbroken but i´m missing the CAN Parameters.

Can anyone tell me where can i find them and what i´ve to do with it?!

My stock DR and FC Files are attached... I need to know where CAN Tables are in both files.

Best regards for your help,
Flo

Also, check out this thread dealing with the same issue:
http://nefariousmotorsports.com/forum/index.php?topic=6993.0

You might have to change CWCS as well.

Hey guys...
Thanks so much for your help...
I don´t understand so much so i don´t know what i´ve to do with "0x131FC" Range ...
What i´ve to do with it?! Open a new scalar, table,...?!
If i open a new scalar with 0x131FC i get "70" in it...


Then... What i´ve to do with 0x10783?! Which is my 360128 File?! If i take 0x10783 as a new scalar into both of my files File i´ll get "19" not 13...

You see, i´m really a noob...
Perhaps i should let everything as it is... I think it´s too complicated for me to code out the fault codes...

Oh man... I don´t really understand what i´ve to do...

i think i should let the fault codes there where they are.

Perhaps i´ll read how to do this in the next winter and then i test it.

Did anyone know where "tjwasiak" is gone?!

He had written for me a FC file without the fault codes... That was a really nice turn from him, but he isn´t active here anymore and don´t answer my PM
I´ll try to find the differences between stock file and the file he had written, but he changed some more on it and i don´t have a well defined xdf for the FC.
But i can´t match them to the DR file so i´m unable to turn the codes off in my DR file...

Much thanks to you all guy to try to help me... But now i see that i´ve much to learn and then i´ll try it...


Best regards,
Flo