Pages: [1]
Author Topic: 2L Stroker 3582r 630cc hitachi MAF hemi throttle body B6 tune  (Read 5301 times)
ReiterPerf
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 23


« on: August 10, 2016, 10:15:03 PM »

Hey, This is my first post. We have put a motor together for a friend and now just working on the tune.

2L FSI crank
JE pistons
IE rods
AEB head
CAT cams
Aftermarket intake
Hemi throttle body
630cc dekas @4 bar w/ return system
040 Pump
Hitachi MAF @85mm
GT3582r w/ header
no cat

The car is drive-able but still in break in (almost 1000Km) I just started tuning KFMSNWDK and KFWDKMSN. I haven't touched KISRM or KUMSRL as I don't know the volume of the intake, or the address for KUMSRL. I would also like to bump up the idle for the cams, but cant find NLLM. I would like to get the hardware changes done before touching any of the other maps. The car runs ok but when you clear codes its hard to maintain an idle for a few minutes. I don't think this has anything to fuel trims as they are pretty close to 0 at idle. What other adaptions are lost when clearing codes? If anyone has locations for NLLM or KUMSRL or xdf with them that would be awesome, or any other advise on tuning for TB and intake that would be great. When I get buddy to take some new logs I will post as well.

Logged
ReiterPerf
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 23


« Reply #1 on: December 02, 2016, 07:52:12 PM »

Car is going pretty good now have a little bit of throttle pulling back at end of 2nd not sure why yet Let me know your thoughts if you have a chance to look at it.
Logged
ReiterPerf
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 23


« Reply #2 on: December 02, 2016, 08:32:56 PM »



Logged
vwaudiguy
Hero Member
*****

Karma: +53/-37
Offline Offline

Posts: 2024



« Reply #3 on: December 02, 2016, 09:16:48 PM »

Sweet intake.
Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
ReiterPerf
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 23


« Reply #4 on: December 27, 2016, 06:29:35 PM »

hey can anyone explain the dying rich and no timing?
Logged
janomari78
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 20


« Reply #5 on: January 17, 2017, 03:58:39 AM »

Hello,
 i was looking your xdf map file and i see that KFMSNWDK and KFWDKMSN are in same memory area. in my file from 1.8t BEX 8A0909518AN they are in KFMSNWDK 1E972 and KFWDKMSN 1EDBC.
Maybe here is problem.

Best regards,
Marijano
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.025 seconds with 17 queries. (Pretty URLs adds 0s, 0q)