Dev Blog
Forum
Wiki
About
NefMoto
>
Noob Zone
>
Noob Questions
(Moderator:
turboat
) >
Clueless and need all the help I can get!
Pages: [
1
]
« previous
next »
Author
Topic: Clueless and need all the help I can get! (Read 5654 times)
Aneves
Jr. Member
Karma: +0/-0
Offline
Posts: 32
Clueless and need all the help I can get!
« on: September 06, 2016, 07:47:32 PM »
What's up guys? Have a mk4 vr6 looking to tune stock engine while learning, I'm building a turbo 2.8 vr6 that I would like to tune once I can get around tuning my own. All and any help greatly appreciated. Need help start to finish, hardware, software and know how!
Logged
nyet
Administrator
Hero Member
Karma: +607/-168
Offline
Posts: 12268
Re: Clueless and need all the help I can get!
« Reply #1 on: September 06, 2016, 07:53:34 PM »
One word of advice. Do not start buying parts until you have your tune fully planned out.
If you buy a random box of parts, and only after you installed them start to worry about your tune, you're fucked.
Logged
ME7.1 tuning guide
ECUx Plot
ME7Sum checksum
Trim heatmap tool
Please do not ask me for tunes. I'm here to help people make their own.
Do not PM me technical questions! Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your ex
Carsinc
Sr. Member
Karma: +17/-2
Offline
Posts: 447
Re: Clueless and need all the help I can get!
« Reply #2 on: September 07, 2016, 05:09:07 AM »
Nyet speaks the truth, that being said there are def some things that can be done.
I'd say its safe to build the bottom end, you know rods and pistons, if stock pitons
plan for a headspacer cause you will be wanting to lower the compression.
Other than that I'm going to tell you the same others will, to go from 0 to VRT in the
tuning world is far from easy and will most likely take years.
Logged
nyet
Administrator
Hero Member
Karma: +607/-168
Offline
Posts: 12268
Re: Clueless and need all the help I can get!
« Reply #3 on: September 07, 2016, 10:18:27 AM »
Quote from: Carsinc on September 07, 2016, 05:09:07 AM
from 0 to VRT in the
tuning world is far from easy and will most likely take years.
x1000
Turboing an NA car is not a good way to start learning.
Logged
ME7.1 tuning guide
ECUx Plot
ME7Sum checksum
Trim heatmap tool
Please do not ask me for tunes. I'm here to help people make their own.
Do not PM me technical questions! Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your ex
vwaudiguy
Hero Member
Karma: +53/-37
Offline
Posts: 2024
Re: Clueless and need all the help I can get!
« Reply #4 on: September 07, 2016, 10:57:17 AM »
Quote from: Carsinc on September 07, 2016, 05:09:07 AM
plan for a headspacer
Try to avoid this. Do it right, or don't bother.
Logged
"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
Carsinc
Sr. Member
Karma: +17/-2
Offline
Posts: 447
Re: Clueless and need all the help I can get!
« Reply #5 on: September 07, 2016, 04:48:58 PM »
I agree but a headspacer is better than stock compression.
Logged
adam-
Hero Member
Karma: +124/-33
Offline
Posts: 2179
Re: Clueless and need all the help I can get!
« Reply #6 on: September 08, 2016, 04:32:30 AM »
Doing it properly is also better than stock compression.
Logged
Aneves
Jr. Member
Karma: +0/-0
Offline
Posts: 32
Re: Clueless and need all the help I can get!
« Reply #7 on: November 05, 2016, 03:42:08 PM »
As far as "hardware" I was speaking in terms of tuning electronically wise. Sorry for the mixup. Mechanically all hardware I have already been collecting it over the past months. I own a shop and have access lots of goodies. Vibrant sure helps a lot. My whole thing is that I would love to build a car and do everything myself, instead of subletting it out. All help greatly appreciated.
Sent from my iPad using Tapatalk
Logged
dokalanyi
Full Member
Karma: +4/-1
Offline
Posts: 119
Re: Clueless and need all the help I can get!
« Reply #8 on: November 16, 2016, 07:59:38 AM »
Aneves,
Not sure what your tuning experience is, but if you're actually clueless as you say, one noob to another:
- Buy a stock 1.8T (K03(s), stock injectors)
- Swap it into your MK4
- Tune that to stage 1
- Change to bigger injectors and Turbo
- Tune to stage 3.
Revisit your VR6.
I could be wrong, but getting the hang of these things is difficult in easy level, you're playing God mode.
Logged
Pages: [
1
]
Print
« previous
next »
Jump to:
Please select a destination:
-----------------------------
General
-----------------------------
=> Introductions
=> General Discussion
-----------------------------
Noob Zone
-----------------------------
=> Noob Questions
=> Noob Guides and FAQs
-----------------------------
Technical
-----------------------------
=> NefMoto Software
=> Tuning
===> Documents & Helpers & How To's
===> Community Projects
=> Diagnostics
=> Flashing and Chipping
=> Cluster and Immobilizer
===> ECU EEPROM images
===> Original Cluster dumps
===> Original Cluster dump requests
=> Data Logging
=> Reverse Engineering
=> Communication Protocols
-----------------------------
ECU Files
-----------------------------
=> ECU Definition Files
===> ECU Definition File Requests
=> Original ECU Files
===> Original ECU File Requests
=> Checksum Update Requests
-----------------------------
Vehicles
-----------------------------
=> Vehicle Tech
=> Project Cars
-----------------------------
Regional
-----------------------------
=> Canadian Regional Discussion
=> US Regional Discussion
-----------------------------
Classifieds
-----------------------------
=> For Sale
=> Wanted
=> Services
-----------------------------
Miscellaneous
-----------------------------
=> Off Topic
=> Forum Tech Support
=> Bizarro Messages Posted by Bots and Spammers
Navigation
Home
Help
Login
Register
Personal Tools
November 24, 2024, 06:31:29 PM
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email?
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Search
Advanced Search
Loading...