I recently sold my last and only VAG car so I don't have a need for any of this stuff since I'm not an Electrical Engineer. All prices are OBO.

The ECU is a 4Z7907551R with a Stock BIN(I believe) only used it to start the car(2003 A6 2.7T) before this listing. It is missing all 4 screws on the back side but the adhesive is very much intact. Price: $100 shipped.



All of below: Price: $95 shipped



The PSU has been modified with switch for easy start/kill and all 12V and ground rails trimmed and made accessible from the outside. Also, soldered to this is a setup for an ME7.1.1 bench flash(ECU pigtail, OBD-II connector, etc). I had planned on putting wire wrap on it after solidifying it was all correct but never got to it. Price: $25

Galletto Cable and Dumb Blue Cable - Price: $20 shipped



USB PIC Programmer with 8-Pin Ponoma SOIC Clip - Price: $50

Sent PM


Sent from my iPhone using Tapatalk

Hello, could u/would u duplicate that set up?
I'll pay u up front, I have the galletto 1260 interface /cables.
K line, lmk thank u.

Sent from my SM-G900V using Tapatalk