hey everyone,

Trying to get hard limiter working but i cant seem to find and xdf file with proper locations to make adjustments. I have 8e0909518f ecu. I cant find kfszt and kftsrl if just all 0. Please help much appreciated, this forum is amazing already got my boost where I want it and cars running great just need some pop pop bang bang  .

thx

thx for reply not sure how i would know sw. But i'm pretty sure ftmon for me is at 1a775 it shows 5. One xdf file i have shows at 1b2ac which is incorrect and where you said i think is incorrect also as it show up 0.

Good evening guys !!!
I set my limiter to 7100 rpms, but the cut comes at 5800 rpms.
Could anyone give a hint how fasso it limit to 7100 rpms?
In this bin I have active AL / NLS.
Very grateful for any help.

Same result.
Limiting to 5800 rpms.
How to reach 7100 rpms?
What am I leaving behind ??

Here is the capture screen.
a question.
I have not changed the axes of the kfzw maps.
Will this be my mistake?
In doubt, I will change everyone and see the result.
Thank you very much for your attention.

Had changed in another file with the same configuration of the kftsrl axes and with the whole column in 0.
But even so the cut came at 5800.
As in wik did not mention about kfszt I decided to leave original for a test.
When the first or second gear pulls off the bursts !!
More in a higher gear limits to the 5800.notei q is tied past the 5000 rpm. strange behavior.
It would not be the case to interpolate the kftsrl axis with a difference smaller than 4000 rpms to 7060 rpms.
Type per line of 6000 rpms in place of 4000 rpms?
I'm going to test that tomorrow.
 thank you

Same result.