Pages: [1]
Author Topic: Brick my me7.5  (Read 4209 times)
kiCK
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 6


« on: February 08, 2017, 11:38:58 AM »

Hello,

Again brick my ecu me7.5 8n0906018bp. Namely flashing with galletto 1260 and there was to 100% and now car not starting, no ecu connected with vcds. I tried flash in bootmode and galletto throws an error writing. I buy mpps v13 and tried flash in bootmode, it's the same as is galletto. I send log file from mpps but i don't decrypt that log. Maybe one of the users will decode that log. If any one has any idea can manage something to do with ecu?
Sorry for my english.

Greets.
Logged
adam-
Hero Member
*****

Karma: +123/-33
Offline Offline

Posts: 2179


« Reply #1 on: February 08, 2017, 11:41:49 AM »

It's obviously not in bootmode.
Logged
kiCK
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 6


« Reply #2 on: February 08, 2017, 11:50:47 AM »

No, because soft galletto or mpps not started if ecu not in bootmode. (pops error) I know when ecu is bootmode or not.
Logged
_nameless
Hero Member
*****

Karma: +342/-466
Offline Offline

Posts: 2799



« Reply #3 on: February 08, 2017, 11:54:55 AM »

well then you shorted and damaged your ecu. good job. i find it hard to believe both tools failed to write unless A) you dont have it in boot mode and/or B) you shorted the wrong pin and the result is a dead pcb.
good luck
Logged

Giving your mom a tuneup
kiCK
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 6


« Reply #4 on: February 08, 2017, 12:02:58 PM »

why read ecu but not write? Wrong pin its not impossible because im not doing this for the first time and never had a problem with the in bootmode. It remains perhaps the only desoldering chip and programming
« Last Edit: February 08, 2017, 12:07:48 PM by kiCK » Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.013 seconds with 17 queries. (Pretty URLs adds 0s, 0q)