Pages: [1]
Author Topic: Can someone help me with the correct format to enter the Chip Select Pin?  (Read 729 times)
SteveAR
Full Member
***

Karma: +3/-1
Offline Offline

Posts: 95



I have two ECM's.   I was able to connect to one of them (ME7.1.1 2.7T Audi Allroad) using this command:

me7eeprom.exe --OBD -r -p 3 read.bin

The software connected and extracted a bunch of information. (VIN/motor/softcode) and saved the eeprom data to the read.bin file.

I then decided to connect to a different ECM out of a 4.2L allroad.  I once used a different tool to connect, and the CS this ECM needed was 6.3.

How do I put that switch into the command line? I see in the help menu there's --CSpin

I've tried a bunch of things (--CSpin 6.3 / --CSpin p6.3 / --CS6.2 / --CSp6.2) but none are recognized by the software.  Can someone give me the correct CS entry format?

Thanks!
Logged
thedrill
Jr. Member
**

Karma: +2/-0
Offline Offline

Posts: 27



« Reply #1 on: February 20, 2017, 10:22:37 PM »

Have you tried the Me7Gui? It works great, just select the tick boxes you want and it does it for you.
Logged
SteveAR
Full Member
***

Karma: +3/-1
Offline Offline

Posts: 95


« Reply #2 on: February 24, 2017, 06:01:27 AM »

I haven't seen that version yet but I will check it out.  I eventually dug up an older post of mine where someone gave me the correct format.  So I've been working in the command prompt. GUI's are nicer though
Logged
Marty
Hero Member
*****

Karma: +52/-32
Offline Offline

Posts: 609


« Reply #3 on: February 24, 2017, 06:10:05 AM »

you need to include the chip kind too
Logged

SteveAR
Full Member
***

Karma: +3/-1
Offline Offline

Posts: 95


« Reply #4 on: February 24, 2017, 07:49:12 AM »

Yes I did that as well.  I've been able to talk to my ECM with the ME7EEPROM TOOL. Thank you

me7eeprom.exe --bootmode 95P08 --CSpin P6.3 -r -p5 eeprom.bin
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.016 seconds with 18 queries. (Pretty URLs adds 0s, 0q)