I keep running into this ive spent some time digging around without finding anything. could any one help me or point me in the right direction. using a rosstech hex cable in dumb mode also have a vagcommander cable.  not quite sure what im missing. i also have no luck with galletto but once again not sure if im missing anything. 100% noob to this. Thanks in advance


Validated FTDI device is in dumb mode.
Disconnected
Connecting...
Starting slow init connection.
Connecting to address 0x01.
Slow init succeeded.
Switching to KWP1281 session.
KWP1281 connect info: 4B0906018P  1.8L R4/5VT     G   0006
Connecting to address 0x01.
Slow init succeeded.
Switching to KWP2000 session.
Connected
Disabling Windows sleep mode.
Reading ECU flash memory.
ECU reports programming session preconditions have been met.
Negotiating communication timings.
Successfully changed to new communication timings.
Requesting security access.
ECU reports that security access is not supported.
Starting diagnostic session.
Disconnecting because no response was received for the Tester Present message.
Disconnected
Reading ECU flash memory failed.
100% complete.
Restoring Windows sleep mode.