Hi,
looking for some help here on Immo file from VW Beatle ECU number 07K 906 032 B. I remove the E2p 8pin device number ST951603 and read it.
I am NOT sure if I read it right because I read it under the protocol of ST95P08 because can't get the ST951603 on the Library. I hear I can use the 95080
W6 but I am not sure. Also did I need to adapt the new immo off  file from the E2p with the Vagcom? Here is the Binary to see if is right and some body can fix it for Immo off.
Thanks again,


Mechtronic

Hi... I get a use same number ECU remove the e2p device read it and try to turn off the immo by doing this changes on the org bin file.
But Immo light still flashing and car starts and dies all the times. Can any body can check the bins to see if I do it right or wrong. also
I diagnose with VAG COM and flag a fault code 02241 - Engine control data not adapted 000 - - both files from e2p are attached org and Immo off,
any help will be appreciated,
Thanks again,
 

Hi !! Remove the ST95P08 burn the new file minus one on the right CS locations but no Luck
Car Immo light still flashing with key on. Car starts and die all the time. By any chance is a
way to turn off Immo or is no way to delete it on the e2p eeprom?? thanks again

Hi ,
I just want to thanks you for your help. I burn the new cal file you send me  on the e2p and car starts perfect. I really aprecite your help.  Can you show me the bytes that really defeat the immo in this file. I have some question can I PM you later during the week?  The only thing is the lmmo light on dash still flashing all time ... is a way to fix that? Thanks again