Pages: [1]
Author Topic: RS4 5120 hack problems  (Read 212 times)
armageddon
Sr. Member
****

Karma: +15/-1
Offline Offline

Posts: 254


« on: June 16, 2017, 02:12:00 PM »

I am helping a friend with his RS4, and doing the linearization runs we hit a problem

At 40% wgdc we change to 4bar sensor and 5120 hack

I am helping a friend with his RS4, and doing the linearization runs we hit a problem

At 40% wgdc we change to 4bar sensor and 5120 hack

The throttle is being close and I can not figure out whats causing it

He is runing 1.1bar wastegate actuatores

I thought it was of being requesting too much too early causing an underboost, but after change that it´s still the same

I suspect KFVPLGU is the problem, on 5120 hack I only divided the axis, does the table need to be divided also?



attached 2 logs, one without throttle closing and one with

the good one is only till 4000rpm cause the battary died

don't mind the wrong scaling, he used the wrong .cfg
Logged
armageddon
Sr. Member
****

Karma: +15/-1
Offline Offline

Posts: 254


« Reply #1 on: June 17, 2017, 04:58:25 AM »

Just to add, I am using the same 5120 hack on mine S4 (with k-box file) without any issue

Logged
armageddon
Sr. Member
****

Karma: +15/-1
Offline Offline

Posts: 254


« Reply #2 on: June 18, 2017, 05:07:30 AM »

any ideas for what is causing throttle cut?
Logged
IamwhoIam
Sr. Member
****

Karma: +14/-15
Offline Offline

Posts: 445


« Reply #3 on: June 18, 2017, 02:24:21 PM »

do you see rlsol_w in your log or am I the only one seeing it?
Logged
vdubnation
Turboman
Global Moderator
Sr. Member
*****

Karma: +43/-1
Offline Offline

Posts: 407


« Reply #4 on: June 18, 2017, 02:41:54 PM »

do you see rlsol_w in your log or am I the only one seeing it?
lol 113 @ 3psi its a mess
Logged
armageddon
Sr. Member
****

Karma: +15/-1
Offline Offline

Posts: 254


« Reply #5 on: June 19, 2017, 03:14:55 AM »

My mistake  Tongue I though that I had lowered it, somehow I did not saved it


Will correct it later today.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.021 seconds with 17 queries. (Pretty URLs adds 0s, 0q)