Pages: [1]
Author Topic: Med9.1 Audi A3 with dsg and BWJ program  (Read 4018 times)
jastr
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 56


« on: August 28, 2017, 08:02:48 AM »

Does anyone have a program for an Audi A3 8p with dsg and cupra BWJ engine? It’s a complete engine swap with all sensors etc it runs fine with cupra med9.1 with Immo off but reports incompatible gear box software.
Logged
aef
Hero Member
*****

Karma: +69/-46
Offline Offline

Posts: 1568


« Reply #1 on: August 28, 2017, 10:24:27 AM »

Have you tried to code it with vcds?
Logged
jastr
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 56


« Reply #2 on: August 28, 2017, 10:25:26 AM »

    Yes. Tried to tell it it was from an Audi and had dsg gearbox but coding refused. Then i tried to code it one setting at a time both settings was rejected
Logged
aef
Hero Member
*****

Karma: +69/-46
Offline Offline

Posts: 1568


« Reply #3 on: August 28, 2017, 10:52:19 AM »

http://nefariousmotorsports.com/forum/index.php?topic=5969.0title=

You can use original sgo/frf if you you find out which S3 8P ECU came with stronic.
maybe this will work.
Logged
jastr
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 56


« Reply #4 on: August 28, 2017, 10:58:08 AM »

However it is not an BWJ engine but a cdl or cdla?
Logged
jastr
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 56


« Reply #5 on: September 06, 2017, 07:44:43 AM »

Did this however it says data had been altered in automatic now? Any ideas to accept the dsg box?
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.054 seconds with 16 queries. (Pretty URLs adds 0.001s, 0q)