Pages: [1]
Author Topic: EDC17C46 Immo off problem safe and start and stop  (Read 4773 times)
romano21
Jr. Member
**

Karma: +0/-5
Offline Offline

Posts: 29


« on: September 06, 2017, 04:41:57 AM »

Hello ALL
I have replace a dead Ecu on an Audi A4 2.0Tdi 143

EDC17C46 2.7
SW: 03L906018AC
HW: 03L906018JL
TC1767

it was replaced by the same version HW and SW
 
I Make immo off in the flash manualy and in the eeprom Checksum ok. Car start but it does not work properly I have the SAFE light on the dashboard and the start function and stop dysfunction. i try many immo off in eproom but not work ! always Safe on dash

I have just tested the method of Weboctopus same result for more information here is the error code I have

in the 05 ACC / START
02241 - Motor control module; vehicle immobilizer not adapated

in 01 Engine P1609 Crash shutdown on
(I Think This one come from the base in the ecu donor)

the car starts and rolls very well. but Safe to Dash
You can help?
Logged
mkxGTi
Full Member
***

Karma: +4/-5
Offline Offline

Posts: 69


« Reply #1 on: November 07, 2017, 05:24:42 PM »

post original flash|eeprom .bins. i'd like the immo off bins aswell. everybody claims they can do it themselves.
Logged
H2Deetoo
Sr. Member
****

Karma: +26/-1
Offline Offline

Posts: 255


« Reply #2 on: January 18, 2018, 02:02:19 AM »

Best solution is to transfer immo from original to donor ecu.
If that isn't possible then immo off in ecu is OK but better do it in eeprom and not in flash.
And to remove the warning/error in cluster then you also need to disable the immo in the cluster.
Logged
superglitch
Jr. Member
**

Karma: +4/-0
Offline Offline

Posts: 45


« Reply #3 on: January 18, 2018, 08:47:16 AM »

There’s no good working solution for this.  Best option is to drive it to dealer, flash to stock and then have them do immo alignment (key adapt is what most call it), if they have issues because vin is different, unplug the ecu until it says to replace the broken ecu.
Logged
bennyboi
Jr. Member
**

Karma: +2/-0
Offline Offline

Posts: 33


« Reply #4 on: January 25, 2018, 09:13:32 AM »

post flash and eep!
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.015 seconds with 17 queries. (Pretty URLs adds 0s, 0q)