Pages: [1]
Author Topic: Disconnecting because no response was received for the Tester Present message??  (Read 6474 times)
EuroXs4
Full Member
***

Karma: +15/-31
Offline Offline

Posts: 209



So I am trying to read this stock ecu on the bench.I am not having any luck with the nefmoto software tool.Any ideas what could be my issue??Ecu is powered up on bench 12vdc approx 2 amps.Immobilizer is disabled.I can connect using same cable to ecu using vcdsliter without issues.


Here is the log from the Nefmotor software:


Validated FTDI device is in dumb mode.
Disconnected
Connecting...
Starting slow init connection.
Connecting to address 0x01.
Slow init succeeded.
Switching to KWP2000 session.
Connected
Disabling Windows sleep mode.
Reading ECU flash memory.
ECU reports programming session preconditions have been met.
Negotiating communication timings.
Successfully changed to new communication timings.
Requesting security access.
Security access granted.
Starting diagnostic session.
Disconnecting because no response was received for the Tester Present message.
Disconnected
Reading ECU flash memory failed.
100% complete.
Restoring Windows sleep mode.
Logged
aef
Hero Member
*****

Karma: +69/-46
Offline Offline

Posts: 1566



go to google:
Quote
site:nefariousmotorsports.com Disconnecting because no response was received for the Tester Present message.

http://nefariousmotorsports.com/forum/index.php?topic=6324.0
power up pin 121
Logged
EuroXs4
Full Member
***

Karma: +15/-31
Offline Offline

Posts: 209



Been there done that.Powered pin 121 up still no dice.Changed baudrate and it appears to be working.Just weird as I'm running win7 ultimate with all the right drivers and using a recommended cable.

« Last Edit: September 14, 2017, 03:43:51 PM by EuroXs4 » Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.013 seconds with 16 queries. (Pretty URLs adds 0s, 0q)