Hi Guys,
I'm struggling to get minimon working with a Porsche ME7.8. I'm working on the bench, and I'm able to get the ECU into boot mode and minimon shows "CONNECTED AND READY", but no matter what range of addresses I try and upload it doesn't work. Minimon gives the message "Error: no data received" and then the status bar shows "NOT CONNECTED". Any help would be appreciated.
Below is the log output from MiniMon and I have also attached my minimon preferences file.
*Loader file Prepare
*Minimon file Prepare
*send Byte 0+ Loader + MinimonCore
*RECEIVE - MC-Identifier: D5
*RECEIVE - LoaderACK 01 received
*RECEIVE - Minimon ACK 03 received
*Minimon successfully launched
*Reset: BUSCON0=0280
*Reset: SYSCON=0600
*Reset Configuration: External Bus disabled
*Reset Configuration: 16 Bit demultiplexed Bus
*Reset Configuration: WR# and BHE# retain their normal function (P0H.0=0)
*Reset Configuration: On chip watchdog timer is disabled (RD#=0)
*Reset Configuration: Lengthened ALE signal
*Initialisation: Memory Unit INTERNALROM activated
*Initialisation: Enable X-Peripherals via SYSCON
*Initialisation: Call EINIT Command
*ERROR: no data received
00 00 00 00 *Loader file Prepare
*Minimon file Prepare
*send Byte 0+ Loader + MinimonCore
*RECEIVE - MC-Identifier: D5
*RECEIVE - LoaderACK 01 received
*RECEIVE - Minimon ACK 03 received
*Minimon successfully launched
*Reset: BUSCON0=0280
*Reset: SYSCON=0600
*Reset Configuration: External Bus disabled
*Reset Configuration: 16 Bit demultiplexed Bus
*Reset Configuration: WR# and BHE# retain their normal function (P0H.0=0)
*Reset Configuration: On chip watchdog timer is disabled (RD#=0)
*Reset Configuration: Lengthened ALE signal
*Initialisation: Call EINIT Command
*ERROR: no data received