Hi
I swapped AJK (2000 eu A6 MT) engine in my a4 b6 1,8T quattro MT, AMB engine.
It starts and run Ok, speedo, tacho, ESP works fine, but I have EPC lamp on cluster and DTC in ECU
18084/P1676/005750 - EPC Warning Lamp (K132) Circuit: Electrical Malfunction
I found, It's a pin48 on ECU, It should be connected to instrument cluster, but 8E cluster has no pin for EPC lamp, unlike 4B cluster.
I guess 8E cluster communicates with ECU just only CAN or/and K-line and receives MIL and EPC request via these lines.
How can I solve these problem? I think my 2.7 ecu doesn't have MIL, but I would like to have working EPC lamp.
I tried to connect pin48 to ground or kl.30 via resistance, but no success.
I tried to code out EPC lamp circuit diagnosis in ESKONF, but I couldn't find Bit to disable.
Orig file attached, I found ESKONF at 14F46
And I need to confirm some maps, please
CWSAWE - 15498
KFNWEGM - 19758
KFTVSA -
Thanks in advance
Upd: EPC lamp Ok! pin48 to kl.30 via 10kOhm resistance
And it works fine, no lamp on normal condition, when disconnect throttle connector - EPC on
Still need for maps
