Pages: 1 [2]
Author Topic: insufficient turbocharging S4 B5  (Read 10972 times)
shelev
Full Member
***

Karma: +0/-2
Offline Offline

Posts: 56



« Reply #15 on: January 27, 2018, 08:48:13 AM »

It's fine if the compressor is close to the walls (if it's within spec), That's part design.
But, it should never touch the walls, but have enough room to expand when hot.

But if there is a lot of play in the shaft, that's a sign of a turbo on its way out.
That might contribute to your underboost problem.

But can't really specify better, without some decent logs with me7logger.
Logged
nyet
Administrator
Hero Member
*****

Karma: +604/-166
Offline Offline

Posts: 12232


WWW
« Reply #16 on: January 27, 2018, 09:49:27 AM »

For the last time, get proper logs.

Obey the forum rules.
Logged

ME7.1 tuning guide (READ FIRST)
ECUx Plot
ME7Sum checksum checker/corrrector for ME7.x

Please do not ask me for tunes. I'm here to help people make their own.

Do not PM me technical questions! Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your experience.
shelev
Full Member
***

Karma: +0/-2
Offline Offline

Posts: 56



« Reply #17 on: January 27, 2018, 10:50:35 AM »

For the last time, get proper logs.

Obey the forum rules.
I have written that I will be able to write down the correct Log only after I will replace turbines!
Logged
shelev
Full Member
***

Karma: +0/-2
Offline Offline

Posts: 56



« Reply #18 on: January 29, 2018, 03:37:32 AM »

It's fine if the compressor is close to the walls (if it's within spec), That's part design.
But, it should never touch the walls, but have enough room to expand when hot.

But if there is a lot of play in the shaft, that's a sign of a turbo on its way out.
That might contribute to your underboost problem.

But can't really specify better, without some decent logs with me7logger.

Today I have read mistakes and I have received
17965 — pressure Regulator наддува:выход from regulation range (it is more than the top limit)
16490 — Pressure on an air intake/pressure => (G71/) F96 a doubtful signal
16621 — the pressurization pressure Sensor too low level of a signal
17956 — the Electromagnetic valve of restriction of pressure of pressurization-N75 break of a chain
Logged
KasperH
Hero Member
*****

Karma: +24/-8
Offline Offline

Posts: 632


« Reply #19 on: January 29, 2018, 07:16:57 AM »

Sound like either you MAP and N75 are trash,
or your engine loom has problems?
Logged
shelev
Full Member
***

Karma: +0/-2
Offline Offline

Posts: 56



« Reply #20 on: January 29, 2018, 09:37:53 AM »

Sound like either you MAP and N75 are trash,
or your engine loom has problems?
Yes, it seems to me too that problems with tubes of turbines (I think that tubes where that have come off)
On the street to look it hasn't turned out, we have cold-37 degrees, will go to a garage tomorrow if it turns out I will write down Log
Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.017 seconds with 18 queries. (Pretty URLs adds 0.001s, 0q)