Pages: [1]
Author Topic: 066906032AG ME7.1 Eeprom flashing problem  (Read 2323 times)
luki9542
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 1


« on: February 12, 2018, 08:27:58 AM »

Hi everyone!

I want to delete immobilizer in my ME7.1 ECU. I bought a blue KKL cable with FT232RL chip and i connected it to obd port in my car. I read EEPROM using ArgDub's tool without any problems. I deleted immo by changing the cells in the memory and then i calculated the checksums. Next i opened my ECU, grounded pin 24 and turned on the ignition. After 3 seconds i deleted ground from the pin 24 and i tried to connect to the ECU in boot mode (me7_95040.exe --bootmode -w -p 2 95040.bin) but i got an error Sad

Quote
Ver: 1.31
Com Port: 2
Baud Rate: 10400
Opening COM2 ... OK
Starting Boot_mode ... FAIL ... No response from ECU. <error=0x07>
Closing COM2

And now the ECU isn't working. I can't turn my engine on and the check lamp on the instrument is off Sad i tried version 1.31 and 1.40 of ArgDub's tools, various baud rates and i tried to write it on the bench too. I can't connect to the ECU in boot mode and in OBD mode, always i get an error 0x07. Is my ECU bricked now?

Thanks for help Smiley
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.021 seconds with 18 queries. (Pretty URLs adds 0s, 0q)