Pages: [1]
Author Topic: modified 95040.bin file  (Read 3508 times)
s1cose
Newbie
*

Karma: +0/-1
Offline Offline

Posts: 6


« on: June 17, 2018, 04:34:30 AM »

hello to all could some please check this bin file for me to see if its good to write back?
i have changred vin number and log in code.

many thanks
Logged
Kukunin
Newbie
*

Karma: +1/-2
Offline Offline

Posts: 20


« Reply #1 on: July 15, 2018, 01:04:16 PM »

Checked, the checksum is correct. But I found that you changed your login only in one spot. It's likely to be an undefined behavior, so you'd better replace `04010404` to `04012f1d` in the fourth line as well to make them match
Logged
adam-
Hero Member
*****

Karma: +124/-33
Offline Offline

Posts: 2179


« Reply #2 on: July 16, 2018, 12:03:20 AM »

6 posts and they all want help? Pft.
Logged
Kukunin
Newbie
*

Karma: +1/-2
Offline Offline

Posts: 20


« Reply #3 on: July 16, 2018, 12:14:39 AM »

6 posts and they all want help? Pft.
It might indicate not that a person is bad, but that the info about the subject is fragmented and hard to understand.
I'm passing this way right now: from flashing my ECU two days ago to disabling immo in EEPROM in boot mode at least 12 hours of active reading has passed. And that's for me, a programmer with a lot of years of experience.

So people naturally go the easier way and ask for help. If you can - you help, if not - ignore, that's ok.
Logged
adam-
Hero Member
*****

Karma: +124/-33
Offline Offline

Posts: 2179


« Reply #4 on: July 16, 2018, 04:46:37 AM »

If I can't find out how to do it though, I'll ask and ask to be shown how someone did it.

OP can use CMD, so he can just use 95040tool to immo off, it's all documented. Smiley If OP needs 95040tool, lmk, I'll send him a link.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.025 seconds with 17 queries. (Pretty URLs adds 0.001s, 0q)