Pages: [1]
Author Topic: MED9.1 - Dsg and Launch control, after released the brakes, car don't run  (Read 337 times)
Khendal
Full Member
***

Karma: +5/-4
Offline Offline

Posts: 164



Hello, does anyone of you have found this problem in a med9.1 dsg car?

For example:

- Setted launch in dsg 5500rpm
- Added LC code in ecu 5500rpm
- Car Launch work at 5500rpm
- Release the brake
- Car don't start the run...

What should be the problem? i ear something about a dsg setting... is there something else to do?

Regards
Logged
gt-innovation
Sr. Member
****

Karma: +24/-0
Offline Offline

Posts: 302



First of all you have to tell us what lc code you are using and what is it doing.

Next thing is to raise the lc from the dsg higher then your code 600+ rpm.

So why do you run your lc at 5500? if your lc works good 4000 to 4500 would be perfect even for glue with any kind of turbocharger.

the reason that your car is not moving is the dsg....

Logged
Khendal
Full Member
***

Karma: +5/-4
Offline Offline

Posts: 164



...
the reason that your car is not moving is the dsg....
Thanks as always, what i though! Wink
... now I have to find out why and which map does not let the car move Huh

See you next year  Grin Cheesy
Logged
gt-innovation
Sr. Member
****

Karma: +24/-0
Offline Offline

Posts: 302



lower your lc from ecu and car will start....the algo you mentioned is just for show off...
Logged
teobolo
Full Member
***

Karma: +6/-4
Online Online

Posts: 88



i usually use 300-400rpm lower for LC in engine ecu than the tcu  and the car starts perfect ...But it needs some testing....
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.023 seconds with 17 queries. (Pretty URLs adds 0.001s, 0q)