Because I’m childish, and childish things are fun.
I decided to make some noise and be able to control it and keep the protective part of the system active and functioning.

So basically, what is being done is letting the N249 and only that open the DV also keeping the overboost protection since it for obvious reasons also uses vacuum reservoir and N249 for that.

All you need is a one-way check valve, and maybe some tubing.
Insert valve in this place and orientation. (MARKED IN RED)

https://drive.google.com/open?id=1kt3qf4mZESGGUFNZB4XvnHNicC9S1sPp

Then all you need to change in the software is KFSSDLDSUA to your desired plsol and nmot.

https://drive.google.com/open?id=1pqA2rChOk-CMQZjVam0D30A8hZKOe6eu

2500 effectively disables the dynamic route for the operation of the DV.
So if you’re within the field where 2500 is entered your DV doesn’t open.
Outside the field the N249 opens the DV and functions properly,
and since you haven’t removed the vacuum reservoir and N249 you get to keep overboost protection.

There might be other ways to do this, but I found this way to give the best control.