Pages: 1 [2]
Author Topic: Golf 4 DSG conversion cluster eeprom coding for FWD and DSG VWK503MH Mfa Only  (Read 896 times)
Eldobi
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 5


« Reply #15 on: September 13, 2018, 08:33:26 AM »

So DSG will understand the Mk4 ‘s ABS ?
Logged
Eldobi
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 5


« Reply #16 on: September 14, 2018, 05:17:44 PM »

Will the dsg understand the signal from me7 ecu with k-line ? What else would be a pain in this project?
Logged
terok
Full Member
***

Karma: +4/-1
Offline Offline

Posts: 80


« Reply #17 on: September 16, 2018, 11:51:29 PM »

K-line is generally not used for control unit to control unit communication. So CAN-bus is the way to go.

So DSG will understand the Mk4 ‘s ABS ?
It should yes, i cannot say for sure about ALL DSG's.
ABS should send CAN id 0x4A0 (Bremse_3) which contains wheel speed information.
Logged
terok
Full Member
***

Karma: +4/-1
Offline Offline

Posts: 80


« Reply #18 on: September 17, 2018, 03:24:16 AM »

What else would be a pain in this project?

One thing that comes to  mind, is speed signal differences.
For example, if you have much different size of wheels (compared to wheels in car that gearbox comes from), DSG will not be happy about it because it measures speed of all the axles in it. If CAN reported speed differs too much, there might be odd behaviour.
On the other hand, if you do not send speed information to DSG at all, it still works suprisingly well.
This is the case in my car, '86 Scirocco in which i have installed a DSG7 from Golf 6.
Logged
Eldobi
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 5


« Reply #19 on: September 17, 2018, 02:22:44 PM »

Thank you so much for the important info.. i’ll start working on it tomorrow and will post the updates Smiley
Logged
Russik123
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 1


« Reply #20 on: September 20, 2018, 10:40:25 AM »

Hey guys,

Im just someone who is passing by. I'm also interested to make a DSG swap with my Audi a3 8l. Im not really sure what I need to do first. I was interested to buy a DSG DQ250. I also found a loom on the internet for like 1200 euro's http://www.pparts.net/nl/dp-dsg-controller-audi-seat-skoda-vw-18-20vt-engines.

My car has like 340 hp and 370nm. The gearbox sucks. Im ready to invest in my car.
Could you please tell the steps or do you have another forum where you started this conversion?

Yours sincerly,

 
Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.016 seconds with 18 queries. (Pretty URLs adds 0s, 0q)