Hello,

I've been doing a lot of reading on this forum over the last few month to understand the Bosch M3.8.3 ECU.  I have a Mk2 Golf with the AGU 1.8T engine fitted.  I've been using an Arduino to create the ABS and Airbag CAN messages so the engine ECU runs without any DTCs.  I did this as I thought the engine might use vehicle speed for fuel cut on overrun.  Anyway it seems, it doesn't have any effect so I want to turn off the CAN monitoring in the calibration.

For ME7 there are several threads on how to do this which describe modifying CW_CAN_R.  It seems however, that the ME7 is quite different to M3.8.3 and I was unable to see any commonality when I started to look at memory addresses.  The KP file I have has no obvious CW_CAN_R equivalent or similar mask.

Does anyone have any experience with this or could give me a few ideas?

Thank you.

Here is the binary I am using:  https://1drv.ms/u/s!AgolWdazE2cjgWvocn2j9Rb5fWi3 

I need to turn off the fuel cut in overcoming, but I can not find the CWSAWE on my AGU 1.8T 150cv 06a906018CJ, do you have any idea where I can find it? or what other means can I use to go to sleep? I also did not find the TVSAG0, all other maps were found!