Pages: [1]
Author Topic: Maxing out MAF, B5 S4  (Read 1192 times)
maxc777
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 11


« on: December 30, 2018, 07:23:41 PM »

Hey guys, was hoping someone would have some experience on this before I buy a new Bosch air mass sensor.

I’m currently running K04 sized turbos at 1.5 bar with 034 85mm maf housing and stock airbox adaptor.

My issue is that my maf scaling is almost back to stock.

In my logs at around 5000 rpm I’m getting 4.97 volts coming out of the maf even with the 85mm housing.

Appreciate any input as I’m stumped.. pressure tested 5+ times, new check valves , pcv you name it.


Sent from my iPhone using Tapatalk
Logged
vwaudiguy
Hero Member
*****

Karma: +47/-35
Offline Offline

Posts: 1968



« Reply #1 on: December 30, 2018, 07:45:18 PM »

That setup and hardware will do what you describe. Get a larger MAF, turn the boost down, or tune around it. MAFs will usually (always?) show less voltage for a given airflow as they age.
« Last Edit: December 30, 2018, 07:48:02 PM by vwaudiguy » Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.012 seconds with 16 queries. (Pretty URLs adds 0s, 0q)